Fixation of dynamic machines on foundations
Filling the empty space under the chassis and base plates (BASE PLATE)
Fill in the blanks around the bolts
Installation of reinforcements
Fixing crane rails
Foundation of super heavy presses and refinery and petrochemical equipment
Very high mechanical resistance
Extremely high adhesion to metal and concrete
No contraction
High vibration resistance
High chemical and thermal resistance
Proper hardening speed
By calculating the cross-sectional volume of grout and considering the specific gravity of 1.8 gr / cm میتوان, the amount of consumption can be determined.
Mix the two components A and C in a certain amount for 1 to 2 minutes with a mixer at 150 to 300 rpm.
Then add component B to their mixture and continue mixing with the above method. The mixed component must be folded up
Use for less than 15 minutes.
Note 1: The reaction of thermosetting process components at ambient temperature is effective in the capture rate.
Note 2: If the height of the epoxy grout is more than 3 cm, the operation should be in steps 3.
Cm and with an interval of about 6 hours.
Note 3: Never expose the material to direct sunlight before mixing.
point:
1- If the cavities are large, clean and dry stone materials can be used 2-7 mm with a weight ratio of one to one.
2- Remove the surface of the substrate from any grease, dust and contaminants, and if the surface has a shell or loose parts, remove them as well.
3- Sub-dry surfaces, if they are concrete or cement mortar, it is necessary to moisten these surfaces before mortar.
4- Roughen polished or smooth surfaces in any way possible (pen and hammer, scratching, etc.).
5- Processing after final polishing is necessary to prevent rapid drying or freezing.
Physical state: Components A and B: Liquid
Part C: Powder
Specific weight: 1.85 kg / cm
Compressive strength: kg / cm² 400 1day ASTM D 695M
kg / cm² 850 7day
kg / cm² 95028day
Flexural strength: 250 kg / cm 1day ASTM D 790
Tensile strength: kg / cm² 210ASTM C 307
Impact resistance: kj / m² 2 ASTM D 256
Adhesion to concrete: kg / cm²630 ASTM D 1002
Initial setting time: 4 hours
Time to reach the final resistance: depending on the air temperature is 4 to 7 days.
Chemical resistance:
Sulfuric acid 50% Excellent Lactic acid is very good
Nitric acid 20% good sodium hydroxide 60% excellent
Citric acid 10% Excellent Bad acetic acid
Sodium sulfate 25% Excellent oxygenated water and bad methanol
Hydrochloric acid 37% Excellent engine oil and gasoline very good
Phosphoric acid 50% Very good Good toluene
Storage conditions and duration: away from cold and direct sunlight and at a temperature of 15 to 25 degrees Celsius in the original packaging away from moisture and cold for 12 months.
As with other chemicals, be careful when storing and working with this product to avoid contact with the mouth, eyes and food, and in case of possible contact, immediately flush the area with plenty of water.
Environmental Tips:
Do not spill excess water or soil.
All products produced and supplied by this company are in accordance with international quality standards.
