Indications :
Repair of cracks and fractures
Smoothing surfaces
Filling cavities and roughness of concrete
Infrastructure of floors and walls before installing new coverings
Concrete remover is a ready-made mortar based on cement with suitable granulation and without shrinkage, which due to the polymers used in the manufacture of this product has a significant adhesion to the substrates.
Complies with ASTM C387, DIN 1045 and DIN 1048 standards.
Repair of cracks and fractures
Smoothing surfaces
Filling cavities and roughness of concrete
Infrastructure of floors and walls before installing new coverings
High adhesion to a variety of materials such as concrete, plaster, brick and ……
The same color as concrete
No contraction
Resistant to frost and thaw cycles
Ease of implementation
High mechanical strength
Resistance to sulfate attacks
Adjustable concentration
Resistance to the penetration of carbon dioxide
Depending on the porosity and unevenness of the applied surfaces, about 1.5 to 2 kg of RW Soft Repair is required to cover one square meter with a thickness of one millimeter.
Clean the work surface from any dust and grease or any kind of dirt. If there are loose areas, remove them. Slowly pour the RW Soft Repair into the pre-poured amount of water in a clean container and stir.
Continue mixing for 2 minutes to obtain a homogeneous mixture. You can adjust it to the desired concentration by adding water or RW Soft Repair powder.
point:
To prepare the above mixture, about 3.28 to 3.8 liters of water per 20 kg RW Soft Repair bag is required.
With a 20 kg RW Soft Repair bag, 14 liters of repair materials can be provided.
The repair surface must be protected from rapid drying, sun, heat, cold and wind, for which purpose you must process the surface after polishing.
Always mix some ingredients with water to be used in less than 30 minutes at most.
If you need to increase the adhesion and seal the surface, the ratio of 1.5 cups of water, 1.5 cups of concrete adhesive and 5 cups of RW Soft Repair can be mixed and used.
Physical state: Tusi powder
Ion Keller: No.
Solubility: in water
Specific weight: gr / cm³75 / 1
Run time temperature: minimum 5 maximum 35 degrees Celsius.
Storage conditions and duration: in the initial packaging away from cold, heat and moisture for 12 months.
Packing: in 25 kg bags.
Cleaning: Wash work equipment with water immediately after finishing work while the mortar is still fresh on it. The dried mortar can be removed mechanically.
As with other chemicals, be careful when storing and working with this product to avoid contact with the mouth, eyes and food, and in case of possible contact, immediately flush the area with plenty of water.
All products produced and supplied by this company are in accordance with international quality standards.
