Description:
In order to achieve high strength concrete and desirable quality, after the concreting operation, a suitable environment should be provided to achieve the maximum possible strength. When concreting in hot weather, certain issues arise, which are mainly due to the rapid evaporation of concrete water. Be. Rapid and intense evaporation of water reduces the efficiency and strength of concrete, shrinkage and surface cracks in it. Curing is a set of measures to complete and complete the hydration of cement in order to achieve the desired strength of concrete The most common method now used all over the world is to cover the concrete surface with a thin layer to prevent evaporation of concrete water, which if used properly, while having the properties of a good curing, will not have a negative effect on concrete. And after a month will gradually disappear due to atmospheric factors. This product is based on silicon and several resin samples and its performance is in accordance with ASTM C309-81 standard.
This material can be used in all large concretes such as water canals, courtyards and hall floors. It is recommended to use it in places where the concrete is exposed to sunlight or wind, which causes the concrete water to evaporate quickly, especially in the southern and tropical regions of the country.
• Ready to use and easy to run.
• Increase hardness and dust-free surface
• Compared to the old methods, the use of curing saves money and manpower. With the use of curing, there is no need to water the concrete.
• There is no need to protect concrete with sacks, nylon, etc. It increases the durability and strength of concrete and prevents it from drying and cracking.
Each kilogram of curing covers 5 to 6 square meters of concrete surface.
Apply the curing on the concrete surface with a brush or a pistol (10 to 30 minutes after the fresh concrete surface has been polished). If the surface is not completely covered, stain it after half an hour.
tip:
If the formwork is used for concreting, run the product on the surface after opening the formwork.
To make it easier to separate the curing layer from the vertical and facade surfaces, you should moisten the desired surface with water before spraying.
Physical state: liquid
Brown color
Solubility: in water
Specific weight: 1/1 gr / cm.
PH: About 7
Packaging: 20 gallons and 220 liter barrels.
Conditions and duration of storage: In the initial packaging and closed away from cold and heat for 12 months.
When working with the solvent base of this product, safety points must be carefully observed. In such a way that there is complete ventilation in the environment. Avoid excessive heat and flame and in case of contact with skin or respiratory mucosa, it is necessary to wash immediately with cold water and see a doctor immediately.
Environmental Tips:
Do not spill excess water or soil.
Quality confirmation:
All products produced and supplied by this company are in accordance with international quality standards.
