Description
Applications:
– Repairing cracks and fractures
– Smoothing uneven surfaces
– Filling voids and imperfections in concrete
– Preparing floors and walls as a base for new coatings
Key Advantages:
✔ Superior adhesion to concrete, plaster, brick, and other substrates
✔ Concrete-like color
✔ Non-shrink
✔ Freeze-thaw resistant
✔ Easy application
✔ High mechanical strength
✔ Sulfate attack resistance
✔ Adjustable consistency
✔ Carbon dioxide (CO₂) penetration resistance
Coverage:
Approx. 1.5–2 kg per m² at 1 mm thickness, depending on substrate porosity and roughness.
Application Instructions:
1. Surface Prep: Clean the substrate from dust, grease, or contaminants. Remove loose or weak areas.
2. Mixing: Gradually add RW Soft Repair powder to clean water (pre-measured in a clean container) while stirring.
3. Blending: Mix for 2 minutes until homogeneous. Adjust consistency by adding water or powder as needed.
Notes:
-Water requirement:3.28–3.8 L per 20 kg bag.
– Yield: One 20 kg bag produces ~14 L of repair mortar.
– Curing: Protect repaired surfaces from rapid drying, sunlight, extreme heat/cold, and wind. Cure properly after finishing.
– Pot life: Use mixed material within 30 minutes.
– Enhanced adhesion/waterproofing: Mix 1.5 parts water + 1.5 parts concrete adhesive + 5 parts RW Soft Repair.
Technical Data:
– Appearance: Gray powder
– Chloride content: None
– Solubility: Water-soluble
– Density: 1.75 g/cm³
– Application temp.: 5–35°C (41–95°F)
– Shelf life: 12 months in original packaging, stored dry (avoid moisture/heat/freezing).
– Packaging: 25 kg bags.
– Cleanup: Wash tools with water immediately after use. Dried mortar requires mechanical removal.
Safety:
– Avoid contact with eyes, mouth, or food. Rinse thoroughly if exposed.
– Wear protective gear as with chemical products.
Environmental:
Do not dispose of excess material in water or soil.
Quality Assurance:
All products meet international quality standards.
